Bruce Web Flasher

Flashing Instructions

Connect your device, then select "Flash" and click connect.

If asked to put your device into download mode, do the following:

• Cardputer: Turn off and unplug from USB, hold the btn G0 (upper right corner), then connect via USB.
• StickCs: Turn off, connect one side of a jumper cable into GND and the other side in G0, plug in USB, then remove the jumper cable.
• T-Embed: Keep encoder center button pressed and press RST button (CC1101 this btn is on the board, beside ESP32-S3 chip).
• T-Deck: Keep the trackpad button pressed and press RST (in the left side).

• If you are in linux, you may need to run sudo setfacl -m u::rw /dev/ttyACM0 to be able to flash.